Ford 2002 Bantam - Crankshaft Rear Oil Seal

303-01B-56 Engine — 1.6L / 1.3L RoCam 303-01B-56
IN-VEHICLE REPAIR
E6638 EN 07/2001 2002 Bantam
Crankshaft Rear Oil Seal
Removal
1. Remove the transaxle. For additional
information, refer to Section 308-03.
2. Remove the clutch. For additional
information, refer to Section 308-01.
3. Remove the flywheel.
4. Remove the oil pan. For additional
informat
ion, refer to Oil Pan in this section.
5. Remove and discard the rear oil seal
retainer and the gasket.
Installation
1. NOTE:
An aligning guide is supplied with
each new rear oil seal retainer.
NOTE:
The sealing lip must be free of oil.
NOTE:
Make sure the aligning dowels are
located.
Install a new rear oil seal retainer.