Ford 2002 Bantam - Electronic Engine Controls

303-14D-226 Electronic Engine Controls — Diesel Engine 303-14D-226
DIAGNOSIS AND TESTING
E7855 EN 09/2001 2002 Bantam
Electronic Engine Controls
Inspection and Verification
1. Verify the customer concern by operating the
system.
2. Visually inspect for obvious signs of
mechanical or electrical damage.
Visual Inspection Chart
Mechanical
Electrical
• Fuel leak(s)
• Vacuum line(s)
• Sensor(s)
• Clutch pedal position
switch
• Wiring harness
• Loose or corroded
electrical connector(s)
• Powertrain control
module
• Sensor(s)
• Clutch pedal position
switch
3. If an obvious cause for an observed or
reported concern is found, correct the cause
(if possible) before proceeding to the next
step.
4. If the concern is not visually evident, verify
the symptom and refer to WDS to diagnose
the system.