Ford 2002 Bantam - Unusual Starter Motor Noise

303-06-209 Starting System 303-06-209
DIAGNOSIS AND TESTING (CONTINUED)
E1017 EN 09/2001 2002 Bantam
CONDITIONS DETAILS/RESULTS/ACTIONS
B2: CHECK THE SUPPLY TO STARTER
1.
2 Measure the voltage between the starter
terminal B, circuit 30 (RD) and ground.
• Is the voltage greater than 12.5 volts?
 Yes
GO TO B3
 No
REPAIR circuit 30 (RD). TEST the system
for normal operation.
B3: CHECK THE STARTER GROUND CIRCUIT
1 Measure the resistance between the starter
motor casing and negative (-) battery terminal.
• Is the resistance less than 5 ohms?
 Yes
INSTALL a new starter motor. TEST the
system for normal operation.
 No
CLEAN and REPAIR grounds as required.
TEST the system for normal operation.
PINPOINT TEST C: UNUSUAL STARTER MOTOR NOISE
CONDITIONS DETAILS/RESULTS/ACTIONS
C1: CHECK THE STARTER MOUNTING
1 Check the starter and mounting brackets for
correct alignment.
• Is the starter mounted correctly?
 Yes
GO TO C2
 No
INSTALL the starter motor.
Refer to the procedure in this section.
TEST the system for normal operation.