205-04-14 Front Drive Halfshafts 205-04-14
REMOVAL AND INSTALLATION
E6459 EN 07/2001 2002 Bantam
Inner Constant Velocity (CV) Joint Boot (14 336 4)
Special Tool(s)
Boot clamp tightening tool
204-169 (14-044)
General Equipment
Snap-ring pliers
Clamping straps
Material
Specification
High-durability grease WSD-M1C230-A
Removal
1. NOTE: Use an Allen key to stop the piston
rod from turning.
Undo the suspension strut top nut by five
turns.
2. Raise the vehicle. For additional
information, refer to Section 100-02.
3. Detach the lower suspension arm from the
spindle carrier.
To Next Page
Loading...
