205-04-15 Front Drive Halfshafts 205-04-15
REMOVAL AND INSTALLATION (CONTINUED)
E6459 EN 07/2001 2002 Bantam
4. Undo the clamping straps on the left-hand
front drive halfshaft boot.
• Slide the boot onto the front drive
halfshaft.
5.
CAUTION: Support the halfshaft. The
inner joint must not be bent at more
than 18 degrees. The outer joint must
not be bent at more than 45 degrees.
Separate the tripod joint of the left-hand
halfshaft.
• Remove the grease from inside the joint.
6. Undo the boot clamps on the right-hand
halfshaft and slide the boot back.
7.
CAUTION: Support the halfshaft. The
inner joint must not be bent at more
than 18 degrees. The outer joint must
not be bent at more than 45 degrees.
Pull the right-hand front drive halfshaft out
of the tripod joint.
• Remove the grease from inside the joint.
• Secure the front drive halfshaft to the
side with cable ties.
To Next Page
Loading...
