205-04-16 Front Drive Halfshafts 205-04-16
REMOVAL AND INSTALLATION (CONTINUED)
E6459 EN 07/2001 2002 Bantam
8. Remove the tripod star and the boot.
• Detach the snap-ring using snap-ring
pliers and pull off the tripod star.
• Pull off the boot.
Installation
1. NOTE: Chamfer points towards the front drive
halfshaft.
Fit the tripod assembly.
• Push on the boot.
• Push on the tripod and secure it.
2.
CAUTION: Support the halfshaft. The
inner joint must not be bent at more
than 18 degrees. The outer joint must
not be bent at more than 45 degrees.
Assemble the left-hand front drive halfshaft
tripod joint using high-durability grease.
To Next Page
Loading...
