Ford 2002 Bantam - Page 150

205-04-17 Front Drive Halfshafts 205-04-17
REMOVAL AND INSTALLATION (CONTINUED)
E6459 EN 07/2001 2002 Bantam
3. Make a clamp head for Special Tool 204-
169.
• Material: aluminium or steel plate
4. Position the tripod joint boot and secure it
with clamping straps.
• Apply the special tool so that the clamp
head is vertical to the clamping strap
head.
NOTE: Tighten 0,8 mm thick clamping straps to
12 Nm and 1,1 mm thick clamping straps to
20 Nm.
• Tighten the clamping strap using the
special tool.
5.
CAUTION: Support the halfshaft. The
inner joint must not be bent at more
than 18 degrees. The outer joint must
not be bent at more than 45 degrees.
Assemble the right-hand front drive
halfshaft tripod joint using high-durability
grease.
6. Position the tripod joint boot and secure it
with clamping straps.
• Apply the special tool so that the clamp
head is vertical to the clamping strap
head.
NOTE: Tighten 0,8 mm thick clamping straps to
12 Nm and 1,1 mm thick clamping straps to
20 Nm.
• Tighten the clamping strap using the
special tool.