Ford 2002 Bantam - Stop Lamps Are on Continuously

417-01-31 Exterior Lighting 417-01-31
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
2 Measure the resistance between rear lamp
assembly, left-hand side, connector C39,
circuit 31-LF23 (BK), harness side and ground.
• Is the resistance less than 2 ohms?
 Yes
CHECK the rear lamp assembly, left-hand
side. If necessary INSTALL a new one.
TEST the system for normal operation.
 No
REPAIR the open circuit(s) between rear
lamp assembly, left-hand side and ground
G4, by using the wiring diagrams. TEST the
system for normal operation.
PINPOINT TEST J: STOP LAMPS ARE ON CONTINUOUSLY
CONDITIONS DETAILS/RESULTS/ACTIONS
J1: CHECK THE STOP LAMP SWITCH
1. 2.
Stop lamp switch
C50
3.
• Are the stop lamps on continuously?
 Yes
REPAIR the short to power; circuit(s)
connected with splice S37, by using the
wiring diagrams. TEST the system for
normal operation.
 No
INSTALL a new stop lamp switch. TEST the
system for normal operation.
E6752 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL