Ford 2002 Bantam - Page 1348

417-01-30 Exterior Lighting 417-01-30
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
2 Measure the resistance between rear lamp
assembly, right-hand side, connector C42,
circuit 31-LF24 (BK), harness side and ground.
• Is the resistance less than 2 ohms?
 Yes
CHECK the rear lamp assembly, right-hand
side. If necessary INSTALL a new one.
TEST the system for normal operation.
 No
REPAIR the open circuit(s) between rear
lamp assembly, right-hand side and ground
G3, by using the wiring diagrams. TEST the
system for normal operation.
I4: CHECK THE POWER SUPPLY OF RE R LAMP ASSEMBLY, LEFT-HAND SIDE A
1. 2.
Rear lamp assem-
bly, left-hand side
C39
3.
4 Depress the brake pedal.
5 Measure the voltage between rear lamp
assembly, left-hand side, connector C39,
circuit 14S-LG41 (VT/BK), harness side and
ground.
• Is battery voltage indicated?
 Yes
GO TO I5
 No
REPAIR the open circuit(s) between splice
S37 and the rear lamp assembly, left-hand
side, by using the wiring diagrams. TEST
the system for normal operation.
I5: CHECK GROUND CONNECTION OF REAR LAMP ASSEMBLY, LEFT-HAND SIDE
1.
E6752 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL