412-00-38 Climate Control System — General Information 412-00-38
GENERAL PROCEDURES
Spring Lock Coupling (34 639 1)
1. NOTE: Select special tool to suit the line
diameter.
Fit the special tool.
• Fit the special tool so that the inner collar
can be guided into the clamping spring.
2. Press the special tool into the clamping
spring.
3. Disconnect the refrigerant line.
• Discard the O-ring seals.
4. Connect the refrigerant line.
• Check the clamping spring for damage.
• Carefully pull out any damaged clamping
springs using a thin piece of wire and
install new one.
E6814 EN 07/2001 2002 Bantam
To Next Page
Loading...
