Ford 2002 Bantam - Clutch Related Vibrations

308-00-11 Manual Transaxle and Clutch — General Information 308-00-11
DIAGNOSIS AND TESTING (CONTINUED)
E6760 EN 07/2001 2002 Bantam
PINPOINT TEST E: CLUTCH RELATED VIBRATIONS
CONDITIONS DETAILS/RESULTS/ACTIONS
E1: CHECK FOR ENGINE COMPONENT GROUNDING
1 Raise and support the vehicle.
REFER to Sec
tion 100-02.
2 Check the engine mount interlocks for ground-
ing on the body or frame.
3 Check the exhaust manifold or other engine
component grounding on the body or frame.
• Is there evidence of grounding on body or
frame?
 Yes
REPAIR or INSTALL a new as necessary.
TEST the system for normal operation.
 No
GO TO E2
E2: CHECK FOR ACCESSORY DRIVE VIBRATIONS
1 Check for accessory vibration at the clutch en-
gage/disengage when engine torque changes.
2 Disconnect the accessory drive belt and check
for vibration.
• Does the vibration stop when the accessory
drive belt is removed from the engine?
 Yes
REPAIR or INSTALL new accessory drive
belt components.
REFER to Section 303-
05.
 No
GO TO E3
E3: CHECK FOR RELEASE BEARING NOISE
1.
2 Depress and hold the clutch pedal.
• Is a whirring, grating or grinding noise present?
 Yes
Install a new clutch slave cylinder.
REFER
to Section 308-02.
TEST the system for
normal operation.
 No
GO TO E4
E4: INSPECT THE FLYWHEEL
1 Remove the transaxle.
REFER to Section
308-03.
2 Inspect for loose flywheel bolts.