Ford 2002 Bantam - Pinpoint Test D: Rough Ride; D1: Check the Suspension Units; Pinpoint Test E: Excessive Noise; E1: Inspect the Suspension

204-00-12 Suspension — General Information 204-00-12
DIAGNOSIS AND TESTING (CONTINUED)
E1049 EN 06/2001 2002 Bantam
PINPOINT TEST D: ROUGH RIDE
CONDITIONS DETAILS/RESULTS/ACTIONS
D1: CHECK THE SUSPENSION UNITS
1 Make sure the tyres are at the correct
pressure.
- Raise and support the vehicle.
REFER to Section 100-02.
- Inspect the suspension units for oil leaks or
damage.
• Are the suspension units leaking or damaged?
 Yes
INSTALL new suspension units as
necessary. REFER to Section 204-01.
TEST the system for normal operation.
 No
Verify the customer concern.
PINPOINT TEST E: EXCESSIVE NOISE
CONDITIONS DETAILS/RESULTS/ACTIONS
E1: INSPECT THE SUSPENSION
1 Raise and support the vehicle.
REFER to Section 100-02.
- Inspect the suspension unit mounting bolts.
• Are the mounting bolts loose or broken?
 Yes
TIGHTEN or INSTALL new suspension unit
mounting bolts. REFER to Section 204-01.
(front) REFER to Section 204-02. (rear).
TEST the system for normal operation.
 No
GO TO E2
E2: INSPECT THE SPRINGS
1 Inspect the springs for damage.
• Are the springs damaged?
 Yes
INSTALL new springs.
REFER to Section 204-01. (front)
REFER to Section 204-02. (rear).
TEST the system for normal operation.
 No
GO TO E3