204-01-12 Front Suspension 204-01-12
REMOVAL AND INSTALLATION
E1055 EN 06/2001 2002 Bantam
Wheel Knuckle (14 343 0)
Special Tool(s)
Separator, Ball Joint
211-020 (13-006)
Adaptor for 204-158
204-158-01 (14-038-01)
Special Tool(s)
Lever, Wheel Knuckle
204-159 (14-039)
Installer, Halfshaft
204-161 (14-041)
General Equipment
Three leg puller
Removal
All Vehicles
1.
CAUTION: Use an Allen key to prevent
the piston rod from rotating.
Loosen the top mount nut by five turns.
1. Remove the cover (if equipped).
2. Loosen the nut five turns.
2.
CAUTION: Use a socket to protect the
retaining nut.
Loosen the wheel hub-retaining nut.
1. Remove the hub cap (if fitted).
2. Bend back the locking tab.
3. Loosen the hub-retaining nut.
3. Remove the front wheel and tyre. For
additional information,
refer to Section 204-03.
To Next Page
Loading...
