204-01-13 Front Suspension 204-01-13
REMOVAL AND INSTALLATION (CONTINUED)
E1055 EN 06/2001 2002 Bantam
4.
CAUTION: Leave the tie-rod end-
retaining nut in place to protect the
ball joint stud.
Loosen the tie rod end-retaining nut.
5.
CAUTION: Protect the ball joint seal
using a soft cloth to prevent damage.
Using the special tool, detach the tie rod
end from the wheel knuckle.
• Discard the tie-rod end-retaining nut.
6.
CAUTION: Secure the brake caliper
and anchor plate assembly out of the
way to prevent damage to the brake
hose.
Detach the brake caliper and anchor plate
assembly.
7. Remove the brake disc.
1. Remove the disc retainer (if equipped).
2. Remove the disc.
To Next Page
Loading...
