206-00-9 Brake System — General Information 206-00-9
DIAGNOSIS AND TESTING (CONTINUED)
E1092 EN 07/2001 2002 Bantam
CONDITIONS
DETAILS/RESULTS/ACTIONS
C3: CHECK FOR FRONT BRAKE VIBRATION
1 Road test the vehicle at 40-80 km/h with light
and medium application of the foot brake.
• Is a vibration present?
Yes
CHECK the front brake discs for excessive
wear or cracks. INSTALL new components
as necessary. TEST the system for normal
operation.
No
Vehicle OK.
PINPOINT TEST D: PEDAL GOES DOWN FAST
CONDITIONS DETAILS/RESULTS/ACTIONS
D1: ROAD TEST THE VEHICLE
1 Road test the vehicle and apply the foot brake.
• Was the brake pedal effort normal?
Yes
Vehicle OK.
No
GO TO D2
D2: CHECK BRAKE FLUID LEVEL
1 Check the brake master cylinder reservoir fluid
level.
• Is the fluid level acceptable?
Yes
GO TO D3
No
CHECK the brake master cylinder reservoir
component tests in this section
REFER to Section 206-00.
TEST the system for normal operation.
D3: PRESSURIZE THE SYSTEM
1 Pump the foot brake rapidly five times.
• Does the brake pedal height build up and then
hold?
Yes
CHECK parking brake adjustment and
ADJUST as necessary. REFER to Section 206-05.
If the condition still exists. BLEED
the brake system. REFER to Section 206-00.
TEST the system for normal operation.
No
GO TO D4
sealing points for leaks.
ADD fluid and BLEED the brake system
Refer to the brake master cylinder
To Next Page
Loading...
