Ford 2002 Bantam - Parking Brake Cable and Conduit (12 675 0)

206-05-8 Parking Brake and Actuation 206-05-8
REMOVAL AND INSTALLATION
E6602 EN 07/2001 2002 Bantam
Parking Brake Cable and Conduit (12 675 0)
Removal
1. Remove the parking brake control cover
trim.
2. Lower the parking brake control lever and
loosen the adjusting nut.
3. Loosen the rear wheel nuts.
4. Raise and support the vehicle.
For additional information,
refer to Section 100-02.
5. Remove the wheel.
6. Detach the exhaust system from the rear
hanger insulators.
7. Disconnect the equalizer from the front
parking brake cable.
• Turn the front parking brake cable nipple
through 90 degrees.