Ford 2002 Bantam - Idle Boom;Shake;Vibration

100-04-44 Noise, Vibration and Harshness 100-04-44
DIAGNOSIS AND TESTING (CONTINUED)
E859 EN 02/2001 2002 Bantam
PINPOINT TEST C: IDLE BOOM/SHAKE/VIBRATION
CONDITIONS DETAILS/RESULTS/ACTIONS
C1: CHECK THE CABLES/HOSES
1 Check the cables/hoses.
- CHECK the engine compartment for any
component that may be grounding between
the engine and body or chassis. Example:
Control cables, A/C hoses, accelerator cable,
etc.
• Are the components OK?
 Yes
GO TO C2
 No
CORRECT the condition as necessary.
TEST the system for normal operation. If the
moan persists, GO TO C2
C2: CHECK THE ENGINE MOUNTS
1 Check the engine mounts.
- Inspect the engine support insulators for
correct operation. REFER to Section 303-
01A.
or REFER to Section 303-01B.
• Is the condition resolved?
 Yes
Vehicle condition corrected.
 No
GO to Pinpoint Test D.
PINPOINT TEST D: ENGINE ACCESSORY VIBRATION
CONDITIONS DETAILS/RESULTS/ACTIONS
D1: CHECK THE ENGINE RUN-UP
1 Check the engine run-up.
- Run the engine up to the concern rpm
observed in the road test, with the vehicle
stationary.
• Does the vibration occur?
 Yes
GO TO D2
 No
CARRY OUT the stall test with the brakes
locked (load the engine by slipping the
clutch in gear). If the vibration occurs,
GO to
Pinpoint Test B.