412-04-9 Control Components 412-04-9
REMOVAL AND INSTALLATION
E1250 EN 07/2001 2002 Bantam
Air Inlet Blend Door Actuator (34 606 0)
Removal
NOTE: "Observe Health and Safety Regulations".
For additional information,
refer to Section 100-00.
1. Standard preparatory measures
• Make a note of the radio keycode.
• Make a note of the preset radio stations.
2. Disconnect the battery ground cable.
3. Remove the instrument panel.
For additional information,
refer to Section 501-12.
4. Remove the actuator.
1. Disconnect the plug.
2. Remove the three screws.
Installation
1. Install the components in reverse order.
2. Connect the battery ground cable.
3. Standard finishing operations.
• Enter the radio keycode.
• Reprogram the preset radio stations.
• Check operation of the actuator.
To Next Page
Loading...
