Ford 2002 Bantam - Passenger Air Bag Short to Battery

501-20B-28 Occupant Restraints — Passive — Supplemental Air 501-20B-28
Bag System
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
J3: CHECK THE PASSENGER A R BAG CIRCUIT FOR A SHORT TO GROUND I
1. 2.
Air Bag Control
Module C334
3 Measure the resistance between:
- - the air bag control module C334 pin 5,
circuit 94S-JA11 (VT/WH) and pin 9, circuit
91-JA10 (BK/RD) harness side; and
- the air bag control module C334 pin 5, circuit
94S-JA11 (VT/WH) and ground; and
- - the air bag control module C334 pin 6,
circuit 91S-JA11 (BK/WH) and pin 9, circuit
91-JA10 (BK/RD) harness side; and
- the air bag control module C334 pin 6, circuit
91S-JA11 (BK/WH) and ground.
• Are the resistances greater than 10,000 ohms?
 Yes
REPEAT the self-test; CLEAR the DTCs.
REACTIVATE the system. REFER to Air
Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS) in
this section.
 No
INSTALL a new air bag wiring harness.
REPEAT the self-test; CLEAR the DTCs.
REACTIVATE the system. REFER to Air
Bag and Safety Belt Pretensioner Supple-
mental Restraint System (SRS) in this sec-
tion.
PINPOINT TEST K: DTC:B1925: PASSENGER AIR BAG SHORT TO BATTERY
CONDITIONS DETAILS/RESULTS/ACTIONS
K1: CHECK THE PASSENGER AIR BAG CIRCUIT FOR A SHORT TO BATTERY
1 Deactivate the supplemental restraint system.
REFER to Air Bag and Safety Belt Preten-
sioner Supplemental Restraint System (SRS)
in this section.
2 Visually check the passenger air bag harness
for damage.
08/2001 2002 Bantam