303-14-240 Electronic Engine Controls 303-14-240
REMOVAL AND INSTALLATION
E6693 EN 07/2001 2002 Bantam
Crankshaft Position (CKP) Sensor — Vehicles with 1.6L / 1.3L Engines (29 230 0)
Removal
1. Remove the engine undershield. For
additional information, refer to Section 502-
00.
2. Disconnect the crankshaft position (CKP)
sensor electrical connector (starter motor
removed for clarity).
3. Remove the CKP sensor (starter motor
removed for clarity).
Installation
1. To install, reverse the removal procedure.
To Next Page
Loading...
