Ford 2002 Bantam - Driver Safety Belt Pretensioner Open Circuit

501-20B-33 Occupant Restraints — Passive — Supplemental Air 501-20B-33
Bag System
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
2 Carry out the self-test with the simulators
installed.
• Does the system prove out correctly?
 Yes
INSTALL a new driver safety belt
pretensioner. REFER to Section 501-20A.
REPEAT the self-test; CLEAR the DTCs.
REACTIVATE the system. REFER to Air
Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS) in
this section.
 No
CHECK the air bag simulator is installed
correctly. REPEAT the self-test; CLEAR the
DTCs. REACTIVATE the system. REFER
to Air Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS) in
this section
PINPOINT TEST O: DTC B1877: DRIVER SAFETY BELT PRETENSIONER OPEN CIRCUIT
CONDITIONS DETAILS/RESULTS/ACTIONS
WARNING: Wait at least one minute after disconnecting the battery ground cable before
disconnecting any supplemental restraint system electrical connector. Failure to follow this
instruction may result in personal injury.
O1: CHECK THE DRIVER SAFETY BELT PRETENSIONER CIRCUIT
1 Deactivate the supplemental restraint system.
REFER to Air Bag and Safety Belt Preten-
sioner Supplemental Restraint System (SRS)
in this section.
2.
3 Carry out the self-test with the simulators
installed.
• Does the system prove out correctly?
 Yes
INSTALL a new driver safety belt
pretensioner. REFER to Section 501-20A.
REPEAT the self-test; CLEAR the DTCs.
REACTIVATE the system. REFER to Air
Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS) in
this section.
 No
GO TO O2
08/2001 2002 Bantam