E9: CHECK THE POWER SUPPLY OF FUSE F22 .............................................417-01-21
PINPOINT TEST F: THE HEADLAMPS ARE ON CONTINUOUSLY
F1: CHECK THE HEADLAMPS............................................................................417-01-21
F2: CHECK THE MULTIFUNCTION SWITCH FOR PROPER FUNCTION ..........417-01-21
F3: CHECK THE RELAY – LOW BEAM F R PROPER FUNCTION .....................417-01-22
F4: CHECK THE CONTROL CIRCUIT OF RELAY –
LOW BEAM FOR SHORT TO POWER...............................................................417-01-22
F5: CHECK THE CIRCUI TO LEFT-HAN LOW BEAM HEADLAMP
FOR SHORT TO POWER ...................................................................................417-01-22
F6: CHECK THE CIRCUI TO RIGHT-HA D LOW BEAM HEADLAMP
FOR SHORT TO POWER ...................................................................................417-01-23
F7: CHECK THE MULTIFUNCTION SWITCH FOR PROPER FUNCTION ..........417-01-23
F8: CHECK RELAY – HIGH BEAM FOR PROPER FUNCTION...........................417-01-23
F9: CHECK THE CONTROL CIRCUIT OF RELAY – HIGH BEAM
FOR SHORT TO POWER ...................................................................................417-01-24
F10: CHECK THE CIRCUIT TO RIGHT-HAND HIGH BEAM HEADLAMP
FOR SHORT TO POWER ...................................................................................417-01-24
F11: CHECK THE CIRCUIT TO LEFT-HAND HIGH BEAM HEADLAMP
FOR SHORT TO POWER ...................................................................................417-01-24/25
F12: CHECK THE INSTRUMENT CLUSTER.......................................................417-01-25
PINPOINT TEST G: THE FLASH-TO-PASS FEATURE IS INOPERATIVE
G1: CHECK THE HIGH BEAM HEADLAMPS FOR PROPER FUNCTION...........417-01-25/26
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL
BACK TO CHAPTER INDEX
Pinpoint Tests
PAGE 2 OF 2
To Next Page
Loading...
