Ford 2002 Bantam - Page 1340

417-01-22 Exterior Lighting 417-01-22
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
F3: CHECK THE RELAY – LOW BEAM F R PROPER FUNCTION O
1. 2.
Relay – low beam
C6
3.
• Are the low beam headlamps on continuously?
 Yes
GO TO F5
 No
GO TO F4
F4: CHECK THE CONTROL CIRCUIT OF RELAY – LOW BEAM FOR SHORT TO POWER
1 Measure the voltage between multifunction
switch, connector C15a, pin 1, circuit 14S-
LE19 (VT/BU), harness side and ground.
• Is battery voltage indicated?
 Yes
REPAIR the short to power, circuit(s)
connected with the multifunction switch,
connector C15a, pin 1, by using the wiring
diagrams. TEST the system for normal
operation.
 No
INSTALL a new relay – low beam. TEST the
system for normal operation.
F5: CHECK THE CIRCUI TO LEFT-HAN LOW BEAM HEADLAMP FOR SHORT TO POWER T D
1. 2.
Fuse F10 (10 A)
(CJB)
3.
4 Check if the left-hand low beam headlamp is
on continuously.
• Is the left-hand low beam headlamp on
continuously?
 Yes
REPAIR the short to power, circuit(s)
connected with the headlamp, left-hand
side, connector C45, pin 2, by using the
wiring diagrams. TEST the system for
normal operation.
 No
GO TO F6
E9418 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL