Ford 2002 Bantam - Page 1630

501-20B-39 Occupant Restraints — Passive — Supplemental Air 501-20B-39
Bag System
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
3 Carry out the self-test with the simulators
installed.
• Does the system prove out correctly?
 Yes
INSTALL a new driver safety belt
pretensioner. REFER to Section 501-20A.
REPEAT the self-test; CLEAR the DTCs.
REACTIVATE the system. REFER to Air
Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS) in
this section.
 No
GO TO R2
R2: CHECK THE DRIVER SAFETY BELT PRETENSIONER FOR LOW RESISTANCE
1.
Air Bag Control
Module C335
2.
Driver Safety Belt
Pretensioner Simu-
lator
3 Measure the resistance between the air bag
control module C335 pin 11, circuit 94S-JA33
(VT/BU) and pin 12, circuit 91S-JA33 (BK/BU)
harness side.
• Is the resistance greater than 10,000 ohms?
 Yes
REPEAT the self-test; CLEAR the DTCs.
REACTIVATE the system. REFER to Air
Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS) in
this section.
 No
INSTALL a new air bag wiring harness.
REPEAT the self-test; CLEAR the DTCs.
REACTIVATE the system. REFER to Air
Bag and Safety Belt Pretensioner Supple-
mental Restraint System (SRS) in this sec-
tion.
08/2001 2002 Bantam