211-02-56 Power Steering 211-02-56
REMOVAL AND INSTALLATION (CONTINUED)
4.
CAUTION: Make sure the self tapping
screw is not inserted more than 2
mm.
CAUTION: Make sure no particles of the
seal enter the steering gear.
Remove the dust cap.
1. Insert the self tapping screw.
2. Ease the dust cap upwards.
5. NOTE: Remove any grease with lint free
paper.
Remove the circlip.
6.
CAUTION: Make sure the pinion
bearing underneath the seal is not
damaged by the punch.
CAUTION: Make sure no particles of the
seal enter the steering gear.
Drive a hole into the oil seal steel cage
approximately 3 mm from the outer edge.
7.
CAUTION: Make sure the pinion shaft
or oil seal housing is not damaged.
CAUTION: Make sure no particles of the
seal or contamination is left inside the
steering gear.
Remove the oil seal.
• Insert the self tapping screw into the seal
no more than 3 mm and prise out the seal.
E5858 EN 07/2001 2002 Bantam
To Next Page
Loading...
