211-02-57 Power Steering 211-02-57
REMOVAL AND INSTALLATION (CONTINUED)
Installation
1.
CAUTION: Make sure the oil seal is
only installed to the minimum depth
in the oil seal housing, which allows
correct location of the circlip into the
retaining groove.
NOTE: Make sure the oil seal housing and
pinion shaft are thoroughly cleaned with lint free
paper. Examine the pinion shaft for signs of
pitting, scoring, wear or corrosion.
Install a new seal.
2. NOTE: Make sure the circlip is correctly
located.
Install the circlip.
• Coat the oil seal and circlip with grease.
3. Install a new dust cap.
4. Install the water splash shield.
• Coat the inside of the splash shield with
grease.
5. Install the steering gear
(refer to procedure
contained in this section).
E5858 EN 07/2001 2002 Bantam
To Next Page
Loading...
