501-20B-14 Occupant Restraints — Passive — Supplemental Air 501-20B-14
Bag System
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
2 Check the air bag warning indicator.
• Is the air bag warning indicator illuminated
continuously?
Yes
GO TO D2
No
GO TO D5
D2: CHECK THE AIR BAG WARNING INDICATOR CIRCUIT
WARNING: Wait at least one minute after disconnecting the battery ground cable before
disconnecting any supplemental restraint system electrical connector. Failure to follow
this instruction may sult in personal injury. re
1.
2 Deactivate the supplemental restraint system.
REFER to Air Bag and Safety Belt Preten-
sioner Supplemental Restraint System (SRS)
in this section.
3.
Air Bag Control
Module C334
4.
Instrument Cluster
C37
5 Measure the resistance between the
instrument cluster C37 pin 16, circuit 91S-JA14
(BK/GN) and the air bag control module C334
pin 4, circuit 91S-JA14 (BK/GN).
• Is the resistance less than 5 ohms?
Yes
GO TO D3
No
INSTALL a new wiring harness. REPEAT
the self-test; CLEAR the DTCs.
REACTIVATE the system. REFER to Air
Bag and Safety Belt Pretensioner Supple-
mental Restraint System (SRS) in this sec-
tion.
08/2001 2002 Bantam
To Next Page
Loading...
