501-11-18 Glass, Frames and Mechanisms 501-11-18
REMOVAL AND INSTALLATION (CONTINUED)
4.
WARNING: Wear gloves and eye
protection when working with the
glass cutting tool as the cutting
operation may produce splinters.
When using the cutter wear ear
protectors. Failure to follow these
instructions may result in personal
injury.
CAUTION: Make sure the cutting blades
are changed where the cutting depth
changes to avoid damage to the body
and trim panels.
NOTE: Some resistance may be encountered
when cutting through the glass locating pegs in
the top corners of the glass.
NOTE: Carefully remove the remaining part of
the locating pegs from the window opening
flange.
From inside the vehicle cut the PU
adhesive at the given maximum depths.
Use the recommended blades, following the
proprietary tool manufacturers instructions.
1. 25 mm.
2. 60 mm.
3. 70 mm.
5. With the aid of another technician, use
suction cups to remove the rear window
glass.
E6780 EN 08/2001 2002 Bantam
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
CONTINUED
BACK TO CHAPTER INDEX
To Next Page
Loading...
