Ford 2002 Bantam - Page 711

303-06-207 Starting System 303-06-207
DIAGNOSIS AND TESTING (CONTINUED)
E1017 EN 09/2001 2002 Bantam
CONDITIONS DETAILS/RESULTS/ACTIONS
2 Measure the resistance between the ignition
switch connector pin 3, circuit 50 (GY) and the
starter relay connector pin 2, circuit 50 (GY).
• Is the resistance less than 5 ohms?
 Yes
RECONNECT the ignition switch.
GO TO A8
 No
REPAIR circuit 50 (GY). TEST the system
for normal operation.
A13: CHECK THE CONTINUITY OF CIRCUIT 50 (GY/BK)
1 Measure the resistance between the starter
motor solenoid connector, circuit 50 (GY/BK)
and starter relay connector pin 3, circuit 50
(GY/BK).
• Is the resistance less than 5 ohms?
 Yes
GO TO A14
 No
REPAIR circuit 50 (GY/BK). TEST the sys-
tem for normal operation.
A14: CHECK CIRCUIT 50 (GY/BK) FOR SHORT TO GROUND
1 Measure the resistance between the starter
relay connector pin 3, circuit 50 (GY/BK) and
ground.
• Is the resistance less than 5 ohms?
 Yes
INSTALL a new starter relay. TEST the
system for normal operation.
 No
REPAIR circuit 50 (GY/BK). TEST the sys-
tem for normal operation.