Ford 2002 Bantam - Page 710

303-06-206 Starting System 303-06-206
DIAGNOSIS AND TESTING (CONTINUED)
E1017 EN 09/2001 2002 Bantam
CONDITIONS DETAILS/RESULTS/ACTIONS
A10: CHECK CIRCUIT 30 (RD) CONTINUITY
1.
Ignition switch
2 Remove the fuse 40 (60A).
3 Measure the resistance between the fuse 40
connector pin 1, circuit 30 (RD) and ignition
switch connector pin 4, circuit 30 (RD).
• Is the resistance less than 5 ohms?
 Yes
GO TO A11
 No
REPAIR circuit 30 (RD). TEST the system
for normal operation.
A11: CHECK THE IGNITION SWITCH
1.
2 Measure the resistance between pin 4 and pin
3 of the ignition switch connector.
• Is the resistance less than 5 ohms?
 Yes
GO TO A12
 No
INSTALL a new ignition switch. TEST the
system for normal operation.
A12: CHECK CIRCUIT 50 (GY) CONTINUITY
1.