501-16-29 Wipers and Washers 501-16-29
REMOVAL AND INSTALLATION (CONTINUED)
5. Remove the bulkhead cover (cont.).
1. Unscrew the bolts.
2. Unclip the connector.
6. Remove the bulkhead cover (cont.).
• Remove the bolt.
7. Remove the wiper motor.
• Unscrew the bolts.
• Unplug the connector.
• Take out the wiper motor with linkage.
Installation
1. Install the wiper motor.
• Connect the plug.
• Position the wiper motor with linkage.
• Tighten the pivot shaft bearing nuts
finger tight.
• Tighten the bolts.
E921 EN 07/2001 2002 Bantam
To Next Page
Loading...
