501-16-30 Wipers and Washers 501-16-30
REMOVAL AND INSTALLATION (CONTINUED)
2. Install the bulkhead cover, working through
the steps in reverse order.
3. Clip the CJB cover in place.
4. NOTE: The wiper motor must be in the park
position.
Fit the wiper arms.
• Tighten the pivot shaft bearing nuts.
• Attach the wiper arms and tighten the
nuts finger tight.
• Connect the battery negative lead.
• Switch on the wipers and check that the
wiper blades move smoothly.
• Tighten the nuts.
5. Standard finishing operations
• Enter the radio keycode.
• Program the pre-set radio stations.
• Reset the clock.
• Carry out a road test to enable the PCM
to collect data.
E921 EN 07/2001 2002 Bantam
To Next Page
Loading...
