501-11-20 Glass, Frames and Mechanisms 501-11-20
REMOVAL AND INSTALLATION (CONTINUED)
6. NOTE: Firmly and evenly press in position;
tape the glass in the correct position until the
PU adhesive has cured.
With the aid of another technician, use
suction cups to install the rear window
glass.
7. Should the ambient temperature fall below
10°C, use a hot air gun at a distance of
approximately 50 mm from the surface and
apply warm air (25°C) continuously for 15
minutes (inside or outside the vehicle).
8. Install the headliner.
• Remove the spacers.
E6780 EN 08/2001 2002 Bantam
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
BACK TO CHAPTER INDEX
To Next Page
Loading...
