204-02-6 Rear Suspension 204-02-6
REMOVAL AND INSTALLATION (CONTINUED)
E6581 EN 06/2001 2002 Bantam
5. Feed the handbrake cable over the exhaust
system and the fuel lines.
Re-hang the exhaust and reconnect the fuel
lines.
Connect the handbrake cable to the
equaliser and fit the clevis pin and spring clip,
reconnect both brake hoses to the axle
bracket.
6. Bleed the brake system. For additional
information, refer to Section 206-00.
7. Lower the vehicle to the ground and finally
tighten all nuts and bolts to the specified
torque. Refer to Section 204-02-17
8. Adjust the parking brake cable. For
additional information,
refer to Section 206-05.
9. Adjust the Load Active Valve (LAV). For
additional information,
refer to Section 206-00
To Next Page
Loading...
