412-02-14 Heating and Ventilation 412-02-14
REMOVAL AND INSTALLATION (CONTINUED)
E1247 EN 07/2001 2002 Bantam
NOTE: Plug the heat exchanger. Do not mix up
the heater hoses during installation (mark them
if required)
8. Disconnect the coolant hoses.
1. Pull off the connector from the heater
control valve.
2. Undo the clamps and detach the coolant
hoses.
9. Remove the heater cover.
• Remove the four bolts.
Vehicles with air conditioning
10. Pull out the evaporator/heat exchanger.
1. Evaporator (push fit)
2. Heat exchanger (push fit)
Installation
NOTE: Torques For additional information,
refer to Section 412- 02, Specifications
NOTE: Before connecting the refrigerant lines,
fit them with new O-rings Coat the new O-rings
with refrigerant oil before fitting them.
1. Refit the components in reverse order.
To Next Page
Loading...
