204-02-11 Rear Suspension 204-02-11
REMOVAL AND INSTALLATION (CONTINUED)
E6583 EN 06/2001 2002 Bantam
Installation
1. Fit the leaf spring into position on the axle
ensuring the colour code is facing towards
the rear of the vehicle.
2. Fit the leaf spring eyebolt and nut.
3. Either fit the rear shackle plate to the spring
and body and refit the spring eye to shackle
plates securing nut and bolt, tighten shackle
upper nut, depending on design fitted.
4. Fit the "U" bolts to the axle and spring,
ensuring that the bump rubber plate is
correctly located regarding shock absorber
mounting. Secure the "U" bolts with there
nuts.
5. Lower the vehicle to the ground and finally
tighten all nuts and bolts to the specified
torque. Refer to Section 204-02-17.
6. Adjust the Load Active Valve (LAV).
For additional information,
refer to Section 206-00
To Next Page
Loading...
