413-01-7 Instrument Cluster 413-01-7
DIAGNOSIS AND TESTING
Self-Diagnostic Mode
Test
Odometer
Displ
ay
Gauge/Indicator/Display
Tested
Description
1. Gauge sweep GAGE
Tachometer, speedometer,
temperature and fuel
All gauges go through an up
and down sweep smoothness
check, which takes app
roxi-
mately five
seconds.
2. Fill in all LCD
All segments
illuminated
Odometer LCD Fills in LCD.
3. Indicator LEDs Bulb
Indicators and warning indica-
tors
Illuminates all the warning in-
dicators that
are controlled by
the instrument cluster.
4. ROM level
r XX PASS or
FAIL
Instrument cluster read only
memo
ry (ROM)
Displays the instrument clus-
ter ROM revision level.
5. Non-volatile mem-
ory level
EE XX PASS
or FAIL
Instrument cluster non-volatile
memo
ry
Displays the instrument clus-
ter non-volatile memory
condition.
6. DTC dtc or XXXX
Diagnostic trouble codes
(DTCs)
To list the DTCs stored, press
the RESET
button.
REFER to the instrument
cluster (DTC) index.
The DTC codes will scroll
through if there is more than 1.
7. Vehicle speed mph EXXX.X Speedometer
Displays the speed signal in-
put in mph.
8. Vehicle speed km/h XXX.X Speedometer
Displays the speed signal in-
put in km/h.
9. Engine speed t XXXX Tachometer
Displays the tachometer input
signal (RPM).
10. Fuel volume F XXX Fuel sender system
Displays the fuel volume sig-
nal input.
11. Engine type Eng -X PCM engine information Displays the engine type.
12. Engine coolant
temperature
XXXC Engine coolant temperature
Displays the engine coolant
temperature signal input.
13. Battery voltage batXX.X Battery Voltage Displays battery voltage input.
14. Illumination IL-[H/L]
Instrument cluster and instru-
ment panel illumination
Displays instrument cluster
and panel illumination.
15. LCD dimming LCdXXX Odometer display
Displays LCD dimming (18%-
100%).
16. Crank sense Cr -X Crank sense circuit
Displays the crankshaft sen-
sor input to the instrument
cluster.
17. Ignition sense IG -X Ignition sense circuit
Displays the ignition input to
the instrument cluster.
18. Washer fluid input LS -X
Status of the low washer fluid
level switch
Displays low washer fluid
switch input.
E1282 EN 09/2001 2002 Bantam
To Next Page
Loading...
