419-01B-13 Anti-Theft — Passive 419-01B-13
REMOVAL AND INSTALLATION (CONTINUED)
E6379 EN 07/2001 2002 Bantam
5. Detach the fuel supply pipe from the two
retaining clips.
6. Remove the injector delivery pipes
7.
CAUTION: When disconnecting the
multiplug do not pull on the wiring;
pull on the multiplug body.
Disconnect the fuel injection pump wiring
multiplug.
8. NOTE:
When dismantling multiplugs /
connectors refer to Connector Repair
Procedure in the appropriate wiring diagram.
Remove the multiplug terminal spacer.
9. NOTE: Note the positions of the terminals in
the multiplug before removing the terminals.
Remove the immobiliser solenoid terminals
from the multiplug.
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
CONTINUED
To Next Page
Loading...
