419-01B-18 Anti-Theft — Passive 419-01B-18
GENERAL PROCEDURES (CONTINUED)
E3809 EN 07/2001 2002 Bantam
4. Turn the ignition lock cylinder to the OFF
position and remove the second key from
the lock cylinder.
5. Within ten seconds of turning the ignition
lock cylinder to the OFF position, insert the
un-programmed ignition key (new key) into
the lock cylinder and turn the lock cylinder
from the OFF position to the RUN position
(maintain the ignition lock cylinder in the
RUN position for less than 5 seconds).
6. Check the new-programmed key starts the
engine. Turn the ignition key to the OFF
position for five seconds then try to start
vehicle with the new programmed key.
7. To programme additional key(s), repeat the
applicable key programming procedure
from step 1.
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
CONTINUED
To Next Page
Loading...
