501-10-9 Seating 501-10-9
REMOVAL AND INSTALLATION (CONTINUED)
All vehicles
5. Remove the seat inner trim panel.
1. Detach the front retaining clip.
2. Detach the rear locating tang.
6. Remove the front seat backrest retaining
clips.
7. NOTE: The seat may be equipped with an
additional inner trim panel, depending on seat
specifications. Care must be taken when
removing the backrest not to damage the
inner trim panel.
Remove the backrest.
1. Fold the backrest forward.
2. Detach the backrest from the spindle.
Installation
1. To install, reverse the removal procedure.
E9366 EN 07/2001 2002 Bantam
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
CONTINUED
BACK TO CHAPTER INDEX
To Next Page
Loading...
