Ford 2002 Bantam - Page 1487

501-11-15 Glass, Frames and Mechanisms 501-11-15
REMOVAL AND INSTALLATION (CONTINUED)
Installation
1.
CAUTION: During the curing period of
the PU adhesive the door windows
must be left open to avoid a build up
of pressure when the doors are
opened and closed.
CAUTION: Avoid touching the trimmed
surface, as this will inhibit the bonding
of the new adhesive.
Remove the excess PU adhesive from the
opening flange.
• Carefully trim the remaining PU adhesive
from the rear window opening flange to
leave approximately 1 mm of trimmed PU
adhesive adhered to the opening flange.
2. Check window aperture sealing area for
damaged sheet metal, rust or foreign
material, which may have caused, or may
cause glass breakage.
3.
CAUTION: To make sure the PU
adhesive cures, it is essential that all
bonding surfaces are free of
moisture.
Using a hot air gun, apply warm air (25°C)
to the opera window opening flange and
glass bond line to remove all traces of
moisture.
4. Prepare the glass, opera window opening
flange and trimmed PU adhesive in
accordance with the instructions supplied
with the adhesive kit.
E6779 EN 08/2001 2002 Bantam
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
CONTINUED
BACK TO CHAPTER INDEX