501-11-28 Glass, Frames and Mechanisms 501-11-28
REMOVAL AND INSTALLATION (CONTINUED)
7. NOTE: Discard the first 100 mm of PU
adhesive as this may have a reduced working
time.
NOTE: To avoid water leaks, any breakage in
the continuous bead should be overlapped by
20 mm.
Apply the PU adhesive in a continuous
bead of between 8 and 10 mm height to the
windshield opening flange along the bond
line.
8. NOTE: Firmly and evenly press in position.
With the aid of another technician, use
suction cups to install the windshield.
9. Should the ambient temperature fall below
10°C use a hot air gun at a distance of
approximately 50 mm from the surface and
apply warm air (25°C) continuously for 15
minutes (inside or outside the vehicle).
10. Install the headliner.
• Remove the spacers.
11. Install the A-pillar trim panels on each side.
E6783 EN 08/2001 2002 Bantam
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
BACK TO CHAPTER INDEX
To Next Page
Loading...
