501-16-19 Wipers and Washers 501-16-19
DIAGNOSIS AND TESTING (CONTINUED)
PINPOINT TEST F: THE WIPERS WILL NOT PARK AT THE CORRECT POSITION
CONDITIONS
DETAILS/RESULTS/ACTIONS
F1: CHECK THE RELAY – INTERMITTENT WIPE FOR PROPER FUNCTION
1.
2.
Relay – intermittent
wipe C48
3.
4 Connect a jumper wire between relay socket –
intermittent wipe, connector C48, pin 1, circuit
31S-AK9 (BK/OG) and pin 3, circuit 31S-AK19
(BK/RD).
• Actuate the SINGLE WIPE: Does the wipers
park in the correct position?
Yes
INSTALL a new relay – intermittent wipe.
TEST the system for normal operation.
No
GO TO F2
F2: CHECK THE POWER SUPPLY (WIPER PARK) OF RELAY – INTERMITTENT WIPE
1 Turn the multifunction switch to the LOW
WIPER SPEED position.
2 Measure the voltage between relay socket –
intermittent wipe, connector C48, pin 1, circuit
31S-AK9 (BK/OG) and ground.
• Is battery voltage indicated?
Yes
GO TO F3
No
GO TO F5
F3: CHECK THE CIRCUIT FOR INTERMITTENT WIPE AND WIPER PARK FOR OPEN
1.
2.
Multifunction switch
C15b
E9432 EN 07/2001 2002 Bantam
To Next Page
Loading...
