501-16-25 Wipers and Washers 501-16-25
DIAGNOSIS AND TESTING (CONTINUED)
Measure the resistance at the windshield wiper
motor, connector C47, between pin 2 and pin 3.
Is the resistance less than 2 ohms?
If yes, GO to 6.
If no, INSTALL a new windshield wiper motor.
6. Check the WIPER PARK function of the
windshield wiper motor
• Connect the battery positive terminal with
windshield wiper motor, connector C47, pin 3.
• Connect the battery negative terminal with
windshield wiper motor, connector C47, pin 1.
• Connect a jumper wire with the windshield
wiper motor, connector C47, between pin 2
and pin 4.
Determine the condition
Does the windshield wiper motor move to the
WIPER PARK position?
If yes, the windshield wiper motor is OK.
If no, INSTALL a new windshield wiper motor.
E9432 EN 07/2001 2002 Bantam
To Next Page
Loading...
