501-20B-18 Occupant Restraints — Passive — Supplemental Air 501-20B-18
Bag System
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
5 Measure the voltage between the air bag
control module C334 pin 4, circuit 91S-JA14
(BK/GN) harness side and ground.
• Is any voltage present?
Yes
GO TO E2
No
CHECK the instrument cluster. For additional
grams.
REPEAT the self-test; CLEAR the
DTCs. REACTIVATE the system. REFER
to Air Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS) in
this section.
E2: CHECK THE AIR BAG WARNING INDICATOR SUB-HARNESS
1.
2.
Instrument Cluster
C333
3.
4 Measure the voltage between the instrument
cluster C333 pin 3, circuit 91S-JA14 (BK/GN)
harness side and ground.
• Is any voltage present?
Yes
REPAIR circuit 91S-JA14 (BK/GN).
REPEAT the self-test; CLEAR the DTCs.
REACTIVATE the system. REFER to Air
Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS) in
this section.
No
INSTALL a new air bag wiring harness.
REPEAT the self-test; CLEAR the DTCs.
REACTIVATE the system. REFER to Air
Bag and Safety Belt Pretensioner Supple-
mental Restraint System (SRS) in this sec-
tion.
08/2001 2002 Bantam
information, refer to the Wiring Dia
Petrol and Diesel
To Next Page
Loading...
