Ford 2002 Bantam - Page 1611

501-20B-20 Occupant Restraints — Passive — Supplemental Air 501-20B-20
Bag System
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
F3: CHECK THE AIR BAG WIRING SUB-HARNESS FOR A SHORT TO GROUND
1. 2.
Air Bag Control
Module C334
3.
Driver Air Bag Mod-
ule Simulator
4 Measure the resistance between:
- the air bag control module C334 pin 2, circuit
94S-JA8 (VT) and pin 9, circuit 91-JA10
(BK/RD) harness side; and
- the air bag control module C334 pin 2, circuit
94S-JA8 (VT) harness side and ground; and
- the air bag control module C334 pin 3, circuit
91S-JA8 (BK/OG) and pin 9, circuit 91-JA10
(BK/RD) harness side; and
- the air bag control module C334 pin 3, circuit
91S-JA8 (BK/OG) harness side and ground.
5 Turn the steering wheel from lock to lock and
note the resistance readings.
• Are the resistances greater than 10,000 ohms?
 Yes
REPEAT the self-test; CLEAR the DTCs.
REACTIVATE the system. REFER to Air
Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS) in
this section.
 No
GO TO F4
F4: CHECK THE DRIVER AIR BAG CIRCUIT
1.
Air Bag Sliding
Contact C349
08/2001 2002 Bantam