501-20B-22 Occupant Restraints — Passive — Supplemental Air 501-20B-22
Bag System
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
6 Measure the voltage between:
- the air bag control module C334 pin 2, circuit
94S-JA8 (VT) and pin 9, circuit 91-JA10
(BK/RD) harness side; and
- the air bag control module C1511a pin 2,
circuit 94S-JA8 (VT) harness side and
ground; and
- the air bag control module C1511a pin 3,
circuit 91S-JA8 (BK/OG) and pin 9, circuit 91-
JA10 (BK/RD) harness side; and
- the air bag control module C1511a pin 3,
circuit 91S-JA8 (BK/OG) harness side and
ground.
• Is any voltage present?
Yes
GO TO G2
No
CONNECT the driver air bag module simu-
lator and the air bag control module.
REPEAT the self-test; CLEAR the DTCs.
REACTIVATE the system. REFER to Air
Bag and Safety Belt Pretensioner Supple-
mental Restraint System (SRS) in this sec-
tion.
G2: CHECK THE AIR BAG WIRING HARNESS FOR A SHORT TO BATTERY
1.
2.
Air Bag Sliding Con-
tact C349
3.
08/2001 2002 Bantam
To Next Page
Loading...
