502-00-6 Uni-Body, Subframe and Mounting Frame — General 502-00-6
Information
REMOVAL AND INSTALLATION (CONTINUED)
Installation
1. Refit the components in the reverse order.
2. Align the crossmember.
1. Push the guide pins through the
crossmember aligning holes.
2. Slide the locking plates into the locking
grooves and tighten the guide pin sleeves.
3. Raise the crossmember engaging the guide
pins into the alignment holes.
E6015 EN 08/2001 2002 Bantam
To Next Page
Loading...
