205-04-34 Front Drive Halfshafts 205-04-34
DISASSEMBLY AND ASSEMBLY (CONTINUED)
E1089 EN 07/2001 2002 Bantam
4. Insert the clamping strap in the groove of
the boot and tighten with the special tool.
5.
CAUTION: Do not damage the bearing
seat of the rollers.
Fit the tripod star.
• Drive the tripod star onto the front drive
halfshaft as far as it will go, using a
suitable tube.
6. NOTE: Use a new snap-ring.
Assemble the tripod joint.
1. Snap-ring
2. Fit the constant velocity rollers, applying
high-durability grease.
7. Attach the intermediate shaft to the front
drive halfshaft.
• Fill the tripod joint with 100 grams of
high-durability grease and fit.
1. Slide a small screwdriver under the boot
seat to allow the air to escape.
2. Slide the tripod joint inwards as far as
the stop, then pull it out 20 mm.
• Remove the screwdriver.
To Next Page
Loading...
