206-00-20 Brake System — General Information 206-00-20
GENERAL PROCEDURES (CONTINUED)
E3164 EN 07/2001 2002 Bantam
5. Operate the brake pedal fully (pumping
brake fluid and air into the bleed jar) and
allow the brake pedal to return to the rest
position.
6. Fill the brake fluid reservoir.
7. Continue operating the brake pedal until air-
free fluid is being pumped into the bleed jar.
8. With the brake pedal fully depressed tighten
the bleed nipple.
9.
CAUTION: Make sure the bleed nipple
cap is installed after bleeding the
brake line(s). This will prevent
corrosion to the bleed nipple. Failure
to follow this instruction may result
in the bleed nipple becoming seized.
Repeat the procedure for the remaining
brake lines.
To Next Page
Loading...
